GORO 20003 (Patented)
Fasteners for Heavy Duty Conveyor Belts

Fasteners made of high tensile coated steel (H.T.S.) or Stainless Steel.

  • Continuous bottom plate to ensure good alignment of the joint 
    and easy introduction of the pin.
  • Reinforced loops with a constant radius.
  • Concealed staples and chamfered edges for protection against hostile effects of belt scrapers.
  • Sealed fasteners available.

Staples pre-mounted in line.

  • Made of High tensile coated steel (H.T.S.)

       GORO 20003

STAPLE SIZE
No.		 Belt Thickness Range Maximum Working Tension PIN

Minimum Pulley Diameter
INCH mm PIW KN./m INCH mm INCH mm
29 19/64 - 11/32 7.5 - 9 800 140 1/4 6 10 250
33 11/32 - 13/32 9 - 11 9/32 7


Packaging

  • Each box contains 2 strips, sufficient to lace 42" (1050 mm) , 48" (1200 mm),  54" (1350 mm), or 60" (1500 mm) of belting.

    Connecting pins not included. Other lengths on request
 Two GORO 20003 Installation Systems (patented) 
 for simple and virtually maintenance free operation 
 

GORO 20003 H-Matic
Robust hydraulic machine, using any power source, such as an electric drill, or an air impact wrench.
Belt clamp incorporated. 
Open ended, it allows continuous lacing of wider belts.

Width: 56" (1400 mm). Other lengths on request.
 

GORO 20003 - FIX: Hammer Tool
The GORO 20003 -FIX hammer tool is used for  installation of  fasteners with a hammer and punch.
Open ended, the tool allows continuous lacing for wider belts.

Width: 56" (1400 mm). Other lengths on request.

 
Top of page      Back to previous page