Fasteners for Heavy Duty Conveyor Belts
Fasteners made of high tensile coated steel (H.T.S.) for high resistance to abrasion.
- Continuous bottom plate to ensure a
good alignment of the splice
and easy introduction of the pin. - Reinforced loops with a constant radius.
- Concealed staples and chamfered edges for protection against hostile effect of belt scrapers.
- Sealing strip available.
Staples pre-mounted in staggered formation, to increase joint strength especially in worn belting. Made of...
- High tensile coated steel (H.T.S.)
- Stainless steel (for Hammer Tool application only).
GORO 20002
| STAPLE
SIZE No. |
Belt Thickness Range | Maximum Working Tension | PIN |
Minimum Pulley Diameter |
||||
| INCH | mm | PIW | KN./m | INCH | mm | INCH | mm | |
| 22 | 19/64 - 11/32 | 7.5 - 9 | 800 | 140 | 1/4 | 6 | 10 | 250 |
| 24 | 11/32 - 13/32 | 9 - 11 | 9/32 | 7 | ||||
| 26 | 13/32 - 1/2 | 11 - 13 | 9/32 | 7 | ||||
| 28 | 1/2 - 19/32 | 13 - 15 | 9/32 | 7 | ||||
Packaging
- Each box contains 2 strips, sufficient to lace 36" (900 mm) , 42" (1050 mm), 48" (1200 mm), or 54" (1350 mm). Connecting pins not included. Other lengths on request
for simple and virtually maintenance free operation
GORO 20002 <HMATIC>
(Patented) -
Utilization
with H.T.S. Staples only
- A robust hydraulic machine, using any power source, such as an electric drill, an air powered impact wrench, etc.
- Belt clamp incorporated
- Open-ended construction allows continuous lacing for wider belts.
The Hammer Tool:
T10H/20002-FIX
- Patented Utilization
with stainless steel staples only
- Easy transportable, simple to operate and maintenance free.
- FIX Hammer Tool is able to install TITAN 10H fasteners and GORO 20002 fasteners in a single operation, with a puch and a hammer.
- Open-ended construction allows continuous lacing for wider belts.