Fasteners made of stainless steel. 
Continuous bottom plate to ensure good alignment of the splice and easy introduction of the pin.
Concealed staples and chamfered edges.
Pre-mounted stainless steel staples.

Connecting Pins
Flexible stainless steel Polymer-coated cable, 1/8" (3mm) diameter.
Grooved stainless steel rod.

Packaging

• Box of 4 complete joints with connecting pins
  Lengths for standard belt width: 12" (300 mm), 18" (450 mm), 24" (600 mm), 36" (900 mm) , 42" (1050 mm), 48" (1200 mm).
  
• Special box for round baler press: Each box contains 6 complete joints
  For use on 7'" (178mm) wide baler belts, plus 6 high 
  Manganese self-hardening steel rod.

T183 Clamping Tool
Mounted in a vice or a small hydraulic press, it allows for the splicing of a 7" wide belt 
(10 fasteners) in an easy and quick manual process. 
Open ended, it allows continuous lacing of wider belts.

Hammer Tool T05/G2000¹ - FIX
Allows the installation of T05 and GORO 2000¹ fasteners with a hammer and punch.

Standard Lengths: 7" (175 mm), 13" (350 mm). 
Open ended, it allows continuous lacing of wider belts.

T161 Hydraulic Machine
Ideal for customers who apply multiple splices on a daily basis. 
Its hydraulic jack, with a manual reset allows the splicing of up to 8" (200 mm) wide belt 
(12 fasteners).

T330 Clamping Tool
Mounted on a hydraulic or mechanical press, it allows for the splicing of a 14" (360 mm) wide belt (22 fasteners) in quick operations.